dl3_001_Product R.E.D. Remark Page
Product Radio Equipment Directive Remark Page
1） Dartslive3, Serial No. WAD201532～ Remark:
For Singapore, IMDA Complies with IMDA Standards, Dealer License: DB106127 Dartslive3 (Model No. DL3-0000) has the following 2 RFID modules. 1) Card reader sensor (Model No. ME-MR23M4-C-SG 2) DARTSLIVE Credit reader (Model No. DLI-00524-B)
Radio frequency range: 13.553 - 13.567 MHz RF Output power: < 37.5 dBuV/m @10m
For Taiwan, NCC Warning 注意！ 本產品內建的 RFID 模組於無線通訊方面符合台灣的 NCC LP0002之法令規範。
依據 低功率電波輻射性電機管理辦法 第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
使用頻段：13.56MHz 變調方式：ASK 可能產生干擾範圍：約 100mm 可否變更頻率：使用所有頻段 並可迴避「內建無線通訊裝置」及「特定低功耗無線通訊裝置」之干擾。
For USA, FCC Caution
DARTSLIVE3(Model No.DL3-0000)(FCC ID:2ARUU-DL30000)
Contains
1)Card reader sensor(FCC ID: UOEME-M23B)
2)DARTSLIVE Credit reader (FCC ID: 2ARUU-DLI00524B)
This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1)This device may not cause harmful interference,and
(2)This device must accept any interference received,including interference that may cause undesired operation.
DARTSLIVE USA INC.
Four Embarcadero Center,Suite 1400 PMB#186,San Francisco 94111-4164 California
Note:This equipment has been tested and found to comply with the limits for a Class A digital device,pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.This equipment generates,uses,and can radiate radio frequency energy and,if not installed and used in accordance with the instruction manual,may cause harmful interference to radio commucications.Operation of this equipment in a residential area is likely to cause harmful interence in which case the user will be required to correct the interference at his own expense.
To ensure compliance with FCC RF exposure requirements,this device must be installed to provide a minimum of 20cm between the device and people.
For 1)and 2),except when used in normal operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Warning: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.